Does MAS support Jumbo frames ? and how do I configure it ?
07-03-2014 02:47 PM
MAS supports Jumbo frames which can be enabled on per-interface basis under the interface. Frame sizes up to 7168 Bytes are supported on the system, default size is 1514 Bytes.
(ArubaS3500) (config) #interface gigabitethernet 0/0/6
(ArubaS3500) (gigabitethernet "0/0/6") #mtu 7168
MTU can be set on interface between 64 and 9216
The supported jumbo frame can be verified by viewing the MTU size on the interface:
(ArubaS3500) #show interface gigabitethernet 0/0/6
GE 0/0/6 is up, line protocol is up
Hardware is Gigabit Ethernet, address is 00:0b:86:6a:2a:c8
Encapsulation ARPA, loopback not set
Configured: Duplex ( AUTO ), speed ( AUTO ), fc ( OFF ), autoneg ( ON )
Negotiated: Duplex ( Full ), speed ( 1000 Mbps )
MTU 7168 bytes
link status last changed 1 day 10 hr 36 min 59 sec
This port is TRUSTED