Wired Intelligent Edge (Campus Switching and Routing)

Reply
Highlighted
New Contributor

How to Storm control on aruba 2930f ?

Dear everyone,

Please help me, I want to configure storm control on all port access switch Aruba 2930f ( Broadcast control and unknown unicast control). 

I search on document and try fault-finder command 

hostconfig)# fault-finder broadcast-storm 3 action warn-and-disable 0 pps 150 

And see below: 

Bcast | Port Rising Disable Disable Time
Port Storm | Status Threshold Action Timer Left
------- ----- + ------ --------- ---------------- ---------- ------------
3 Yes | Down 150 pps warn-and-disable 0 -

 

But i want to config all interface port storm control broadcast pps and storm control unicast pps 

I read this guide but can not create:

https://community.arubanetworks.com/t5/Wired-Intelligent-Edge-Campus/How-to-configure-Storm-Control/ta-p/186800

 

Frequent Contributor I

Re: How to Storm control on aruba 2930f ?

 

Take a look at the rate-limit command. It is described in chapter 6 of the Management and Configuration Guide.

 

 

MVP
MVP

Re: How to Storm control on aruba 2930f ?

Hi,

 

I build most 2930F configurations with the following settings. Maybe it will help you with making your choices.

 

fault-finder broadcast-storm sensitivity high
fault-finder bad-driver sensitivity high
fault-finder bad-transceiver sensitivity high
fault-finder bad-cable sensitivity high
fault-finder too-long-cable sensitivity high
fault-finder over-bandwidth sensitivity high
fault-finder loss-of-link sensitivity high

interface 1/1
   rate-limit bcast in percent 10
   rate-limit mcast in percent 10
   exit

spanning-tree 1/1 admin-edge-port
spanning-tree 1/1 bpdu-protection
Kind Regards Marcel Koedijk
HPE ASE Flexnetwork | ACMP | ACCP | Ekahau ECSE Design - Was this post usefull, Kudos are welcome.
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: