Hi Davide,
Thanks, well the situation is a bit different the person before me who configured the core switch didnt really configured it properly.
On my core side 2 switches stacked together while on access switch(2930f) stacked together. I have configured the same lacp type
but there is one thing I'm little lost is
1) Does both side ports in lacp need to have same operation key which in this instance core switch has Opr key : 963 while on access switch Opr key is 533
2)show lacp peer, on core gives me this LACP MODE=Active, while same command on 2930f switch gives me LACP MODE=Passive. Is that issue, please note I haven't connected the new switch with core yet but just wanted to know if this is the default state on lacp
syd-3810# show lacp peer
LACP Peer Information.
Local Local Port Oper LACP Tx
Port Trunk System ID Port Priority Key Mode Timer
------ ------ ----------------- ----- --------- ------- -------- -----
1/3 Trk2 703018-854901 50 32768 16394 Active Fast
2/3 Trk2 703018-854901 114 32768 16394 Active Fast
Not connected yet
SYD-SWL8-STACK# show lacp peer
LACP Peer Information.
Local Local Port Oper LACP Tx
Port Trunk System ID Port Priority Key Mode Timer
------ ------ ----------------- ----- --------- ------- -------- -----
1/50 Trk2 000000-000000 50 0 0 Passive Fast
2/50 Trk2 000000-000000 103 0 0 Passive Fast
And also I have been trying to find document on configuring dhcp-snooping but no luck while I can find for dhcpv6 snooping.
Do you got some sort of info or commands or document I can refer to config dhcp-snooping.
Thanks for your help.
Rish