Wired Intelligent Edge (Campus Switching and Routing)

Contributor II

Mobility Switch

I have a design question.  I have a customer that would like to install the Aruba switches in tunneled node.  However, they would like to have it where if the master controller failed it will just operate like a L2 switch.  Is this supported?  If so how would you go about programming such a setup?


Re: Mobility Switch


That is not currently supported.


You can have a backup controller configured or point the TN ports to a VRRP address of a controller pair.


Best regards,



Contributor II

Re: Mobility Switch

Okay. That is what I thought but before I told the customer no I wanted to check. Thank you for responding!
Search Airheads
Showing results for 
Search instead for 
Did you mean: