Wired Intelligent Edge (Campus Switching and Routing)

Reply
New Contributor

Monitoring 2930F switches

Hello,

We are installing some 2930F switches in a customer environment, they want all of them to be monitored via SNMP. I haven't been able to download the MIBs for this switch.

Basically, I need to check CPU, memory utilization and environmental variables like fans and temperature, is it possible? I see that the command "show system temperature" doesn't exist, so I can't even check it via CLI.

Could anyone lend a hand here, please?

MVP Expert

Re: Monitoring 2930F switches

Greetings!

 

SNMP MIBs can be downloaded from HPE Support (there's one MIB repository for the entire Aruba/HP switching lineup).  For the 2930F, that will cover CPU and memory utilization (as well as interface statistics and other common parameters); however, I do not believe this platform has (at present) environmental monitoring statistics accessible from either the CLI or SNMP.  I'll check with our team here to find out if there is any method of getting that info.



Matt Fern
Technical Marketing Engineer, Wired Intelligent Edge

Aruba, a Hewlett Packard Enterprise company

8000 FOOTHILLS BLVD  |  ROSEVILLE, CA 95747
T: 916.540.1759  |  E: mfern@hpe.com   |   Matt @ Twitter
New Contributor

Re: Monitoring 2930F switches

Hi Matthew

Thank you very much for the link, that will help a lot, I am still getting used to the HPE support website.

I'll try with those MIBs, I think it is what I needed.

 

Regards,

Dan

 

New Contributor

Re: Monitoring 2930F switches

i have guide config snmp, and airwave

New Contributor

Re: Monitoring 2930F switches

Was there any update on the ability to monitor the hardware sensors on the 2930F's 16.08.01 still doesn't seem to provide basic statistics we should be getting from the HP mibs.

CPU Load, Free Memory,PSU,Temp,FAN state
 
TIA
New Contributor

Re: Monitoring 2930F switches

Yes, to monitor CPU and memory, you do it through the standard SNMP UIDs, however, my switches didn't have any fan or temperature sensors, in consequence, there is no way to monitor them.
New Contributor

Re: Monitoring 2930F switches

The environmental values is what we are looking for.

Fan Status and POE usage are avaiable through the GUI, currently not via SNMP.

MVP Expert

Re: Monitoring 2930F switches

You can use/look also API...



PowerArubaSW: Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP... More info

PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...) More info

PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)

PowerArubaIAP: Powershell Module to use Aruba Instant AP

PowerArubaMC: Powershell Module to use Mobility Controller / Master


ACMP 6.4 / ACMX #107 / ACCP 6.5 / ACSP
Occasional Contributor II

Re: Monitoring 2930F switches

can you share oid you used for your switch?

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: