Wired Intelligent Edge (Campus Switching and Routing)

Reply
Occasional Contributor I

Not able to enable Multicast Routing on 2930F

Running firmware 16.05.0004 on a JL259A

 

sw# config

sw(config)# ip multicast-routing

Invalid input: multicast-routing

 

What am I doing wrong?

 

 

Thanks

MVP Expert

Re: Not able to enable Multicast Routing on 2930F

Greetings!

 

The command should be present in the global configuration context; when you type 'ip' and then a question mark to show possible config parameters, what do you see?



Matthew Fern
Technical Marketing Engineer, Wired Intelligent Edge

Aruba, a Hewlett Packard Enterprise company

8000 FOOTHILLS BLVD  |  ROSEVILLE, CA 95747
T: 916.540.1759  |  E: mfern@hpe.com
Occasional Contributor I

Re: Not able to enable Multicast Routing on 2930F

Thank you.

 

It turns out my switch was running from the secondary image (older firmware)

 

Everything is running OK after forcing the swicth to boot from the primary image (16.05.0004)

 

Thanks again.

 

 

 

 

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: