Wired Intelligent Edge (Campus Switching and Routing)

Reply
Highlighted
Contributor II

Prioritize voice traffic on Aruba 2930

Hi Guys,

In fact I have a simple setup but i'm not too familiar with Aruba switches.

My setup:

I have 2 VLANS Voice & Data

My configs:

vlan 5
name voice
voice
tagged 1

vlan 10
name data
untagged 1

How can I prioritize the voice traffic ?

Thank


Accepted Solutions
Highlighted
Aruba Employee

Re: Prioritize voice traffic on Aruba 2930

Hi,

 

You can do with the below

 

Syntax: vlan <vid> qos priority <0-7>

 

Example:

 

switch(config)# vlan 10 qos priority 4

 

The qos priority default setting is 0 (normal), with 1 as the lowest priority and 7 as the highest priority.

 

Please refer to Advanced Traffic Management Guide for ArubaOS-Switch : https://support.hpe.com/hpesc/public/docDisplay?docId=a00091305en_us for more detailed explanation.

 

Hope it helps.

View solution in original post


All Replies
Highlighted
Aruba Employee

Re: Prioritize voice traffic on Aruba 2930

Hi,

 

You can do with the below

 

Syntax: vlan <vid> qos priority <0-7>

 

Example:

 

switch(config)# vlan 10 qos priority 4

 

The qos priority default setting is 0 (normal), with 1 as the lowest priority and 7 as the highest priority.

 

Please refer to Advanced Traffic Management Guide for ArubaOS-Switch : https://support.hpe.com/hpesc/public/docDisplay?docId=a00091305en_us for more detailed explanation.

 

Hope it helps.

View solution in original post

Highlighted
Occasional Contributor II

Re: Prioritize voice traffic on Aruba 2930

Using the voice command in the vlan already enables some qos and enables LLDP-MED.

 

You can fine-tune it using manual commands, but in my experience, in a "normal" office environment, it is not needed.

But then again I don't know your environment...

 

You can read up more in this post:

https://community.arubanetworks.com/t5/Wired-Intelligent-Edge-Campus/Voice-VLAN-on-Aruba-switches/td-p/417811 

Highlighted
MVP Expert
MVP Expert

Re: Prioritize voice traffic on Aruba 2930

See also this topic:

https://community.arubanetworks.com/t5/Wired-Intelligent-Edge-Campus/Voice-VLAN-on-Aruba-switches/td-p/417811

 

Use a voice vlan and use tagged vlans to your phones. The DHCP values pre-configured on your phones will be honored by the switch interface.

 

Note that QOS need be set end-to-end, so from phone, on all interconnect switches, firewalls to the VOIP server. But for my understanding a voice vlan take care on that.

  

Kind Regards Marcel Koedijk
HPE ASE Flexnetwork | ACMP | ACCP | Ekahau ECSE Design - Was this post usefull, Kudos are welcome.
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: