Hi, I'm a little confused about the optimal configuration for my particular case.
I have two Aruba 2930F and suppose I want to make a VSF between them with two physical ports for redundancy. Currently I have it configured like this:
vsf enable domain 9000 member 1 type "JL259A" mac-address 9cdc71-37da40 priority 255 link 1 1/23 link 1 name "I-Link1_1" link 2 1/24 link 2 name "I-Link1_2" exit member 2 type "JL259A" mac-address 9cdc71-362fe0 priority 128 link 1 2/23 link 1 name "I-Link2_1" link 2 2/24 link 2 name "I-Link2_2" exit port-speed 1g exit
Reading the documentation I think I understand that it would be best if I had 1 VSF link of two ports, this way:
vsf enable domain 9001 member 1 type "JL259A" mac-address 08f1ea-4a4020 priority 255 link 1 1/23-1/24 link 1 name "I-Link1_1" link 2 name "I-Link1_2" exit member 2 type "JL259A" mac-address 548028-6068e0 priority 128 link 1 2/23-2/24 link 1 name "I-Link2_1" link 2 name "I-Link2_2" exit port-speed 1g exit
If this last configuration is the best, could I make the configuration change in such a way that it doesn't affect the network traffic too much?
If so, how should I proceed in this case?
Thank you in advance for your assistance.
Solved! Go to Solution.
The second is better (the first solution will don't work with only two if you look vsf status / topology)
Yes, you can make change (Need to remove the port for link 2 and add to link 1)
PowerArubaSW: Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP... More info
PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...) More info
PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)
PowerArubaIAP: Powershell Module to use Aruba Instant AP
PowerArubaMC: Powershell Module to use Mobility Controller / Master
ACMP 6.4 / ACMX #107 / ACCP 6.5 / ACSP