Wired Intelligent Edge (Campus Switching and Routing)

Reply
Highlighted
Occasional Contributor I

Remove a port of a VSF link and add to another

Hi, due to a bad configuration, I need to remove a port from a VSF link to add it to another VSF link.
In my case I have VSF Link 2 operative, and VSF Link 1 in error state.
I want to remove the VSF Link 1 port and add it to VSF Link 2, minimizing the network interruption.
How should I proceed?

There are two Aruba 2930F. Attached are samples of how it is currently configured.

show vsf link detail

 VSF Member: 1     Link: 1
 Port     State
 -------- ------------
 1/23     Error: Port connected to self

 VSF Member: 1     Link: 2
 Port     State
 -------- ------------
 1/24     Up: Connected to port 2/24


 VSF Member: 2     Link: 1
 Port     State
 -------- ------------
 2/23     Error: No response from peer

 VSF Member: 2     Link: 2
 Port     State
 -------- ------------
 2/24     Up: Connected to port 1/24
show vsf topology

 VSF member's interconnection with links:

 Stby     Cmdr
 +---+    +---+
 | 2 |2==2| 1 |
 +---+    +---+


Thank you very much in advance.
Best regards

 

Gabriel

Re: Remove a port of a VSF link and add to another

no vsf member 1 link 1 1/23

vsf member 1 link 2 1/23

 

same for member 2:

no vsf member 2 link 1 2/23

vsf member 2 link 2 2/23

 

Connect all ports into the single vsf link

 

you can just add a new interface to the existing vsf link



- - - - Aruba ACCX #748, ACDX #758, ACMP, ACEAP | HPE Master ASE - - - -
- - - - - - - Feel free to give kudos or accept as a solution! - - - - - - - - -
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: