Wired Intelligent Edge

Hi,

im trying to configure a S2500 switch with an Aruba controller 6000, as i understand the MAS work as an AP and i want to see the MAS on the controller and create roles and authentication per port on the S2500.

The port GE 0/0/17 is connected in the VLAN 5 in access mode where is all the management ip of all the campus AP's and tunelled mode  to the controller.

The config is:

interface-profile switching-profile "UNI"
   access-vlan 5
interface-profile tunneled-node-profile "default"
   controller-ip 10.225.1.150

interface gigabitethernet "0/0/17"
   tunneled-node-profile "default"
   switching-profile "UNI"

but i dont see it in the aruba controller as an AP, what do i need to see it in the Aruba controller??

The objective of this demo is connect wired users and apply roles and dinamic VLANs by 802.1x

Any suggestions?

Do you see it under "Wired Access Points"?

Can you run show tunneled-node state and show tunneled-node config on the controller?

it not see under wired access points

the output:

(aruba-master) #show tunneled-node state

Tunneled Node State

-------------------

IP  MAC  s/p  state  vlan  tunnel  inactive-time

--  ---  ---  -----  ----  ------  -------------

(aruba-master) #show tunneled-node config

Tunneled node Server:Enabled

Tunnel Loop Prevention:Disabled

in the log i see this:

(aruba-master) #show log all | include  00:1a:1e:0f:7e:40

Aug 15 13:29:23  stm[1824]: <304001> <ERRS> |stm|  Unexpected stm (Station management) runtime error at mux_harvest, 1315, Heartbeat Timeout 00:1a:1e:0f:7e:40 S2 P30

Aug 15 14:28:15  stm[1824]: <304001> <ERRS> |stm|  Unexpected stm (Station management) runtime error at mux_harvest, 1315, Heartbeat Timeout 00:1a:1e:0f:7e:40 S2 P29

The MAC 00:1a:1e:0f:7e:40 is from the S2500, any suggestions?

Regards

Can the Mobility Access Switch ping the Mobility Controller? Can you attach the configurations files from the MAS and MC?

Best regards,

Madani