Wired Intelligent Edge (Campus Switching and Routing)

Reply
Highlighted
Occasional Contributor I

State is INIT (Group Disabled) under VRRP in ArubaOS-CX

Hi Everybody!

 

I ran into a silly issue today while setting up VRRP on ArubaOS-CX. I had all the configs place & still i dint have Master & backup in VRRP for the only group(100) in which i had them configured. Ran sh vrrp ipv4 100 to see the below o/p-

 

switch# sh vrrp ipv4 100

VRRP is enabled

Interface 1/1/1 - Group 100 - Address-Family IPv4
State is INIT (Group Disabled)
State duration
Virtual IP address is 192.168.100.1
Advertisement interval is 1000 msec
Version is 2
Preemption is enabled
min delay is 0 sec
Priority is 255
Master Router is 0.0.0.0
Master Advertisement interval is 1000 msec
Master Down interval is 3003 msec

 

 

Took some time & the solution was in " No shutdown "  under the specific group.

 

Configs before  " No shutdown "

------------------------------------------

switch# sh run vrrp
router vrrp enable
interface 1/1/1
vrrp 100 address-family ipv4
address 192.168.100.1 primary
exit

 

 

Configs after " No shutdown "

-----------------------------------------

switch# sh run vrrp
router vrrp enable
interface 1/1/1
vrrp 100 address-family ipv4
address 192.168.100.1 primary
no shutdown
exit
switch#

 

Offcourse the saviour came from ArubaOS-CX Virtual Switching
Extension (VSX) Guide for 10.01.

 

Hope this helps for somebody!

 

Thanks to Aruba Team for letting out the Configuration Guide!

 

 

 

MVP Expert

Re: State is INIT (Group Disabled) under VRRP in ArubaOS-CX

Why do use Active Gateway ?




PowerArubaSW: Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP... More info


PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...) More info


PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)


PowerArubaIAP: Powershell Module to use Aruba Instant AP




ACMP 6.4 / ACMX #107 / ACCP 6.5

Re: State is INIT (Group Disabled) under VRRP in ArubaOS-CX

Please remind that all physical ports on ArubaOS-CX (8400, 8320, 8325) are shutdown by defaul, whatever they are L2 or L3 ports.

This is also true for LAG.

This is for better control of new switch insertion in the core/agg network layer (no port is active by default).

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: