Wired Intelligent Edge (Campus Switching and Routing)

Reply
Highlighted
New Contributor

Storm Control

Does anyone know how to configure Multicast storm control on 2530? Something similair to this -> https://community.arubanetworks.com/t5/Wired-Intelligent-Edge-Campus/How-to-configure-Storm-Control/ta-p/186800

 

Cheers

MVP Expert

Re: Storm Control


@DaveB91 wrote:

Does anyone know how to configure Multicast storm control on 2530? Something similair to this -> https://community.arubanetworks.com/t5/Wired-Intelligent-Edge-Campus/How-to-configure-Storm-Control/ta-p/186800

 

Cheers


this example is for comware i think

but you have the same setting on ArubaOS using rate-limit

 

2530(config)# interface 1 rate-limit
all Set a rate limit for all traffic.
bcast Set a rate limit for broadcast traffic.
icmp Set a rate limit for ICMP traffic.
mcast Set a rate limit for multicast traffic.
unknown-unicast Set a rate limit for unicast flood traffic.

 




PowerArubaSW: Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP... More info


PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...) More info


PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)


PowerArubaIAP: Powershell Module to use Aruba Instant AP




ACMP 6.4 / ACMX #107 / ACCP 6.5

Re: Storm Control

Hi Dave,

As Alexis told you, that command is a way to simulate some kind of storm control.

You can refer to page 124 of this manual:

https://support.hpe.com/hpsc/doc/public/display?docId=a00061561en_us

Regards


PS: If you feel this information is useful and solved your question or problem, please do not forget to mark it as a solution and give me some kudos.
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: