Wired Intelligent Edge (Campus Switching and Routing)

Reply
Occasional Contributor I

aruba switch - vlans missing in menu

hello gentleman.

 

i colleguejust came by and asked me why there aren't all vlans shown in the menu. i see all vlans set at vlan names, but in the vlan port assignement i am missing some of them. is there a max number for vlans to be shown in the vlan menu?

CLI is fine

 

cheers,

raffa

Aruba Employee

Re: aruba switch - vlans missing in menu

Hi Raffa, 

 

I believe the menu window that you're looking at, the vlan address table, just shows the current mac-addresses that are on that specific port and VLAN.

 

I think the information that  you want to see is under "switch configuration" -> "VLAN Menu" -> "VLAN Port Assignment".

 

 vlan menu.PNG

Hope this helps, 

 

Regards, 

 

Justin

 

JUSTIN NOONAN
TECHNICAL MARKETING ENGINEER – ARUBA WIRED INTELLIGENT EDGE
O: +1 916 540 1748   |   justin.noonan@hpe.com

8000 FOOTHILLS BLVD  |  ROSEVILLE, CA 95747 USA

GARTNER AGREES: VISIONARY LEADER IN CAMPUS NETWORKING

 

Occasional Contributor I

Re: aruba switch - vlans missing in menu

hello justin

thats the point - i am in the vlan port assignment menu. but if i go to the right, a few vlans are missing. if i go to vlan names, all the vlans are there.

that is why i am asking if there is a maximum for vlans to be shown in the port assignment menu.

hope you can follow.

regards,
raffa
Aruba Employee

Re: aruba switch - vlans missing in menu

Hi Raffa, 

 

The menu interface only supports displaying up to 32 VLANs for VLAN port assignment, you'll need to use the CLI to assign ports to more than 32 VLANs.

 

This is documented in the Advanced Traffic Management Guide on Page 35.

 

https://support.hpe.com/hpsc/doc/public/display?docId=a00050236en_us

 

Regards, 

 

Justin

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: