Wireless Access

Hi,

I set it up in the CLI and saved it.

When checked in show running-config, the settings are not changed.

However, when you check the web, the settings have changed.

It does not seem to change only in the CLI.

Does anyone know why?

Thank you.

What setting?

What steps did you use to make the change?

Where are you looking at it in the CLI?

Hi,

Do I have to change the mode?

You have not said what setting and where you are trying to apply it.

Hi,

For example, if you change the IP of the VLAN interface, it does not change when you check show running-config in the CLI.

However, it was changed normally when you checked it on the web.

Thank you.

If you are on the MM, show running configuration shows the configuration for the MM.  You need to CD to the MD and type MDC to enter the MD and then type "show running-configuration"

The controller is running standalone.

Do I have to check the same?

Thank you.

I honestly do not know.  I have little experience with standalone controllers on ArubaOS 8.x.  Maybe someone else can help.