Wireless Access

last person joined: 21 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

AMP 8.2.7 showing AP-305 as AP-50

This thread has been viewed 3 times

  • 1.  AMP 8.2.7 showing AP-305 as AP-50

    Posted Nov 04, 2018 10:05 PM

    Hi Guys,

     

    i have AMP running 8.2.7 version but showing AP-305 as AP-50.

    based on release note, AMP support for AP-305 should be available since 8.2.4.

    anyone have a fix this issue?



  • 2.  RE: AMP 8.2.7 showing AP-305 as AP-50

    EMPLOYEE
    Posted Nov 05, 2018 03:53 AM

    You might consider posting this in the Network Management section: https://community.arubanetworks.com/t5/Network-Management/bd-p/NetworkManagement

     

    Is this for an isolated AP or all the AP-305 under your AirWave appliance? I don't have this particular model available but I would try and re-add the device or re-poll the controller it is associated with.

     

    If that does not help, best way to go would be with TAC, to identify any potential bug.



  • 3.  RE: AMP 8.2.7 showing AP-305 as AP-50

    EMPLOYEE
    Posted Nov 05, 2018 07:11 AM
    @rickylee wrote:

    Hi Guys,

     

    i have AMP running 8.2.7 version but showing AP-305 as AP-50.

    based on release note, AMP support for AP-305 should be available since 8.2.4.

    anyone have a fix this issue?

    Are you sure it is an AP-305?  Did you recently upgrade Airwave?



  • 4.  RE: AMP 8.2.7 showing AP-305 as AP-50

    Posted Nov 05, 2018 09:50 PM

    Hi Owehrli, Hi Collin,

     

    sorry for posting in the wrong section and thanks for the help.

     

    we have 205 and 305, all 205 are showing correct AP type. All of the 305 showing as AP-50.

    the server was originally running in 8.2.0 when adopting 305 and showing this wrong ap type which later upgraded to 8.2.7 but still showing as AP-50 even after re-poll them.



  • 5.  RE: AMP 8.2.7 showing AP-305 as AP-50

    EMPLOYEE
    Posted Nov 11, 2018 09:51 PM

    I would suggest opening a TAC case, so that they can check the DB and see the value getting updated and also, see what controller return on manual poll.