Wireless Access

Occasional Contributor I


Hello All,


I have a question. I have an issue where I was getting interference issue with few of my APs. I chose of the AP with poor quality then make it a spectrum analysis. That rebooted the ap and AP never come back up.


I beleive the AP does not come back up because of the incorrect group. What is the easiest way of getting the AP up without impacting other APs.


One way, I think I can do this is to re-configure the AP with the appriate group, but doing that would impact the other APs.

2. Is to confure one more and shipped to the club. That requires a lift and tech which will  $$$$$$$$ lots of it.


Now since I have two  controllers I think it can be done without worrying about the other APs as they would fail over the other controller.


Any ideas will be appriciated.






Guru Elite

Re: AP-105

Type "show ap database" to see if the access point has reached the controller but is misconfigured.

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Search Airheads
Showing results for 
Search instead for 
Did you mean: