Wireless Access

New Contributor

AP-205's 5.Ghz and 2.4Ghz not booting properly



I'm having problems with regards to AP-205 for the past few days. So, here's the problem:


We're trying to boot up one of the APs that we have in our office but, only Power and Enet boots up and both of them blinking continuously. We're trying to wait for 5-10 mins to see if the 2.4Ghz and 5Ghz led indicator will boot up but, it won't boot up. We tried to purge the configurations but it won't boot at all.


EDIT: It has also standby IP when this thing happens


Do you know anything that causes like this? Thanks.

Super Contributor II

Re: AP-205's 5.Ghz and 2.4Ghz not booting properly

Would it be possible for you to post the output of a console session while it is booting up? That should start us in the right direction.



Dustin Burns
Senior Mobility and Access Engineer @WEI
ACMX #509 | ACCX #1272 | ACSA | ACDA | ACEA | CCNP | CCDP | CCNA Wireless

If my post address your queries, give kudos and accept as solution!
Search Airheads
Showing results for 
Search instead for 
Did you mean: