Wireless Access

This community is currently in a read-only state due to a maintenance window. For more info click here
Reply
Highlighted
Occasional Contributor II

AP-225 pass through operation

Does the AP-225 support pass through operation on the wired Ethernet ports similar to how this exists on the AP-125, for example?

I realize that doing this would defeat full 802.11ac capacity requirements, but this would be acceptable in order to start our deployment in areas that only have one wire drop.  Cabling would then be upgraded at a later point.


Accepted Solutions
Highlighted
Moderator

Re: AP-225 pass through operation

Yes, you can use the second port as an access port as long as .at power is being supplied to the access point.



If this response is more than 1 year old, it may no longer be accurate. Please consult official Aruba documentation, TAC or your Aruba SE.

| Aruba Alumni | @timcappalli | timcappalli.me |

View solution in original post


All Replies
Highlighted
Moderator

Re: AP-225 pass through operation

Yes, you can use the second port as an access port as long as .at power is being supplied to the access point.



If this response is more than 1 year old, it may no longer be accurate. Please consult official Aruba documentation, TAC or your Aruba SE.

| Aruba Alumni | @timcappalli | timcappalli.me |

View solution in original post

Highlighted
Occasional Contributor II

Re: AP-225 pass through operation

Great - thanks for the info Tim.  I couldn't be completely clear about it from the data sheets.