Hello All,
I have a single AP134 that shows up on the MC GUI as ap name "default ap" in the default AP Group. It is listed as "I"nactive. It responds to pings and can be rebooted from the MC, but when trying to open the AP installation page, the page remains blank and it cannot be provisioned. I have also tried rebooting from the POE Switch:
Aruba3600), Version 6.1.2.7
(MC1) #ping 10.136.7.21
Press 'q' to abort.
Sending 5, 100-byte ICMP Echos to 10.136.7.21, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4.847/5.3726/6.038 ms
default ap default 134 10.136.7.21 Up 14m:11s
AP "default ap" AP to Switch Message Counts
-------------------------------------------
Message Total New Acknowledged
------- ----- --- ------------
HELLO 1 1 1
AP_READY 1 1 1
KEEPALIVE 1 1 1
CHAN_PWR_CHANGE 0 0 0
PROV_RESULT 0 0 0
FLASHING 0 0 0
REBOOTING 0 0 0
BW_REPORT 0 0 0
OVRTEMP 0 0 0
STATUS_REPORT 1 1 1
LED_RESPONSE 0 0 0
PORT_CLEAR_RESPONSE 0 0 0
CSR 0 0 0
Source IP Destination IP Prot SPort DPort Cntr Prio ToS Age Destination TAge Flags
-------------- -------------- ---- ----- ----- ---- ---- --- --- ----------- ---- -----
10.135.124.132 10.136.7.21 17 8211 8211 0/0 0 0 1 1/1 13 FY
10.135.124.132 10.136.7.21 47 0 0 0/0 0 0 0 1/1 454 F
10.136.7.21 10.135.124.132 17 8211 8211 0/0 0 0 1 1/1 13 FC
10.136.7.21 10.135.124.132 47 0 0 0/0 0 0 0 1/1 454 FC
To all intents and purposes the AP is there, but it will not come up on the installation page to provision it. It is ceiling mounted in a Warehouse at a remote site so I do not have console access. I can telnet to the AP, but no commands are possible.
My question is, can an AP be purged from a telnet session? If so, how?
Thanks
Dave