Hey,
i have the following problem:
I have an 345 which wants correctly connect to our MM.
set device anul0 mtu to 2000
Starting watchdog process...
Aruba watchdog daemon started [1 thread(s)]
LLDP not sent yet, DHCP is waiting
Starting DHCP
net.ipv4.conf.all.arp_notify = 1
Getting an IP address...
[ 28.001000] device eth0 entered promiscuous mode
net.ipv4.conf.all.arp_notify = 0
net.ipv4.conf.br0.arp_notify = 1
x.x.x.x 255.255.252.0 x.x.x.x
Running ADP...Done. Master is x.x.x.x
[ 43.720909] wl 0000:01:00.0: enabling device (0000 -> 0002)
[ 43.823111] wifi0: AP type AP-345, radio 0, max_bssids 16
[ 44.174786] usbcore: registered new interface driver usbserial
[ 44.237540] usbcore: registered new interface driver usbserial_generic
[ 44.315785] usbserial: USB Serial support registered for generic
[ 44.393424] usbcore: registered new interface driver cp210x
[ 44.454549] usbserial: USB Serial support registered for cp210x
AP Reboot reason: Power-reset
shutting down watchdog process (nanny will restart it)...
<<<<< Welcome to the Access Point >>>>>
I checked the Master IP, it is correct and worked for many other APs before.
At our controller i checked the whitelist entry for this AP:
(xxx) *#show whitelist-db cpsec mac-address 90:4C:81:C0:75:EE
Control-Plane Security Whitelist-entry Details
----------------------------------------------
MAC-Address AP-Group AP-Name Enable State Cert-Type Description Revoke Text Last Updated
----------- -------- ------- ------ ----- --------- ----------- ----------- ------------
90:4c:81:c0:75:ee Enabled certified-factory-cert factory-cert Thu Feb 28 15:39:22 2019
Total Entries: 1
I tried to take the AP only today, but it won´t show at our MM. How can i verify, what is causing the problems? We also tried factory resetting the AP.
Thanks in advance and kind regards
Daniel