Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

AP104 usage with two ANT-1b antenna

This thread has been viewed 2 times

  • 1.  AP104 usage with two ANT-1b antenna

    Posted May 23, 2014 09:12 AM

    Hi, 

     

    I have a AP104, i can use only two antennas of ANT-1b on it. one for 5Ghz and another for 2.4Ghz. 

     

    Which port i must use A0 or A1 for each R0 and R1 ?

     

    what configuration tuning i must do.. 



  • 2.  RE: AP104 usage with two ANT-1b antenna

    EMPLOYEE
    Posted May 23, 2014 09:29 AM

    Here you go:

     

    R0/A0: Radio 0 (5GHz), chain 0

     

    R0/A1: Radio 0 (5GHz), chain 1

     

    R1/A0: Radio 1 (2.4GHz), chain 0

     

    R1/A1: Radio 1 (2.4GHz), chain 1



  • 3.  RE: AP104 usage with two ANT-1b antenna

    Posted May 24, 2014 12:43 AM

    Thank you Seth, 

     

    I have two antennas only, one for each band. Which antenna port, i have to use for best signal coverage. A0 or A1? 



  • 4.  RE: AP104 usage with two ANT-1b antenna

    EMPLOYEE
    Posted May 24, 2014 06:51 AM
    This is not recommended. Either use the 2.4 or 5 radio only and shut off the one not in use. Or purchase two other antennas


  • 5.  RE: AP104 usage with two ANT-1b antenna

    Posted May 24, 2014 07:06 AM

    @SethFiermonti So, there should be no antenna port that is left open, right.?

     

     



  • 6.  RE: AP104 usage with two ANT-1b antenna

    EMPLOYEE
    Posted May 24, 2014 07:18 AM

    Yes - no port left open unless you disable that radio (in case you don't have 4 antennas)