Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

AP125 Spectrum Monitor - graphs not showing

This thread has been viewed 0 times

  • 1.  AP125 Spectrum Monitor - graphs not showing

    EMPLOYEE
    Posted May 15, 2012 10:27 PM

    Hi,

     

    I have a few AP125s in a particular group and applied a dot11g radio profile in which it is 'spectrum-mode'.

     

    When I connect to that spectrum monitor, it shows that it does not support Real time FTT, FTT Duty Cycle or Swept Spectrogram, as in the diagram.

     

    Spectrum - NLD.jpg

     

    I was under the impression that these APs should support that.

     

    OS version is 6.1.2.4.

     

    Thanks



  • 2.  RE: AP125 Spectrum Monitor - graphs not showing
    Best Answer

    Posted May 15, 2012 11:57 PM
      |   view attached

    AP-12x and RAP-5WN have limited support for spectrum monitoring. Real time FFT, FFT Duty Cycle, swept spectrum, and interface source classification are not supported.

     

    Please refer to KB article Answer ID 1130 at link: http://support.arubanetworks.com/ArubaOSKB/tabid/111/Default.aspx 

     

    The same info can also be found in the attachment.



  • 3.  RE: AP125 Spectrum Monitor - graphs not showing

    EMPLOYEE
    Posted May 16, 2012 08:29 AM

    ok, fair enough.  I've changed that radio profile back to 'ap-mode' but when I do a 'show ap active' it still shows them as Spectrum.

     

    Not sure what to do with that.

     

    Thanks