AP135 is plugged into Cisco 3560x switch and lldp is enabled as well. But it shuts down eth1 port due to insufficient power.
Any ideas?
You need 802.11at in order to get power on e1 and the 3560 supports 802.11af instead.
What code are you running? This behavior has been changing a bit in recent releases.
Prior to 6.2, only layer 1 negotiation for 802.3at POE was supported. With 6.2, LLDP can be used to identify an 802.3at source.
/Onno Harms, Aruba
@vfabian - 3560X supports POE+
The code is 6.1.3.8. This means I need to use a POE injector for the AP?
If you need the second ethernet port, you should either use an 802.3at midspan, or upgrade to 6.2.
I also had to upgrade the IOS image on Cisco 3560X to get it working. (12.2 => 15.0)
missed the "x"
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.