Wireless Access

last person joined: 22 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

AP225 LACP LMS IP with 6.4.2.x

This thread has been viewed 0 times

  • 1.  AP225 LACP LMS IP with 6.4.2.x

    Posted May 20, 2015 10:54 AM

    We have two controllers in a master/standby config with a VRRP ip address.  I am also trying to configure LACP LMS IP information and having trouble.

     

    I followed the documentation Aruba has, but the AP-225 Enet1 is still in standby mode.  For the LMS IP information, I used the same LMS IP listed under AP System profile (our VRRP ip) and the Striping IP was +1.  I rebooted the AP225 - it does show the striping IP but Enet1 is still in standby mode. 


    #AP225


  • 2.  RE: AP225 LACP LMS IP with 6.4.2.x

    Posted May 20, 2015 10:59 AM

    HI,

     

    Which controller and which AOS code you are using ?

     

     



  • 3.  RE: AP225 LACP LMS IP with 6.4.2.x

    EMPLOYEE
    Posted May 20, 2015 11:16 AM
    Is your switch configured for LAG with LACP for each AP? What does the switch show for LACP status.


    Thanks,
    Tim


  • 4.  RE: AP225 LACP LMS IP with 6.4.2.x

    Posted May 20, 2015 01:29 PM

    Controllers: 

    7210

     

    AOS:

    6.4.2.4

     

    Switch output


    LACP

    LACP Trunk Port LACP Admin Oper
    Port Enabled Group Status Partner Status Key Key
    ---- ------- ------- ------- ------- ------- ------ ------
    A5 Active Trk1 Up Yes Success 0 290
    A6 Active Trk1 Up Yes Success 0 290


    #7210