Wireless Access

Reply
Highlighted
Contributor I

AP225 LACP LMS IP with 6.4.2.x

We have two controllers in a master/standby config with a VRRP ip address.  I am also trying to configure LACP LMS IP information and having trouble.

 

I followed the documentation Aruba has, but the AP-225 Enet1 is still in standby mode.  For the LMS IP information, I used the same LMS IP listed under AP System profile (our VRRP ip) and the Striping IP was +1.  I rebooted the AP225 - it does show the striping IP but Enet1 is still in standby mode. 

Highlighted
Valued Contributor II

Re: AP225 LACP LMS IP with 6.4.2.x

HI,

 

Which controller and which AOS code you are using ?

 

 

Cheers,
Venu Puduchery,
[Is my post helped you ? Give Kudos :) ]
Highlighted
Moderator

Re: AP225 LACP LMS IP with 6.4.2.x

Is your switch configured for LAG with LACP for each AP? What does the switch show for LACP status.


Thanks,
Tim


If this response is more than 1 year old, it may no longer be accurate. Please consult official Aruba documentation, TAC or your Aruba SE.

| Aruba Alumni | @timcappalli | timcappalli.me |

Contributor I

Re: AP225 LACP LMS IP with 6.4.2.x

Controllers: 

7210

 

AOS:

6.4.2.4

 

Switch output


LACP

LACP Trunk Port LACP Admin Oper
Port Enabled Group Status Partner Status Key Key
---- ------- ------- ------- ------- ------- ------ ------
A5 Active Trk1 Up Yes Success 0 290
A6 Active Trk1 Up Yes Success 0 290

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: