Hi!
Sorry, I'm a little late, but better than never....
I was able to figure out the couse of the broken GUI last week when I was upgrading a customers environment.
Check out this topic: AOS 8.4.x GUI not fully functional after MCM migration from 6.5.x
I restored the config to 6.5.0.16 and migrated a second time to 8.3.
The migration to 8.4 will convert the controller to master mode, not to standalone and this will kill the GUI (looks like MM afterwards).
If you use 8.3, it will work....
------------------------------
Best regards, mom
------------------------------
Original Message:
Sent: Jan 28, 2021 04:41 AM
From: Tobias Gabriel
Subject: Addind ap to a standalnoe controller using arubaOS 8.4
Hi,
I have the same problem.
Did you restore the config or did you have to retype everything?
thanks
------------------------------
Tobias Gabriel
Original Message:
Sent: Dec 03, 2019 08:22 PM
From: Matthias Moritz
Subject: Addind ap to a standalnoe controller using arubaOS 8.4
@tamar wrote:
Hi
It was a problem with the upgrade/migration proccess.
HPE's support team worked on it for couple of days and there at least we had to re-configure the controller.
Hi!
I'm facing the same issue right now.
Where you able to restore the configuration, or does this break the GUI again?
Do we have to do a factory reset and type in every single line of config?
Thank you!