Wireless Access

Reply
Highlighted
New Contributor

Aruba 303 Configuration Urgent

Good Day .

I just installed a new IAP 303 to my office (  I’ve already have 4 ap’s are works very well ) .

As you see in the attached below the new AP after configuring in the same subnet it become red in the virtual controller and the name of it is the mac address ( I’ll give it a name )

I turned auto join off to see the Ap , when I enable the auto join the Ap does not appear as you see in the immage below .

Aruba.jpg

Please I need your support in this case to configure this AP .

Highlighted
Guru Elite

Re: Aruba 303 Configuration Urgent

Why did you turn auto join off?

 

EDIT:  You should be able to reboot that access point after you turn auto join back on and it should join.

 

If it does not join, SSH into the Virtual controller and type "show log system" to see why it could be rejecting it.


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Aruba Central Documentation
ArubaOS Consolidated Release Notes
Aruba VIA ASE Solution - Configure VIA VPN
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: