Wireless Access

last person joined: 23 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Aruba AP 205 802.11n in All Access Points

This thread has been viewed 0 times

  • 1.  Aruba AP 205 802.11n in All Access Points

    Posted Jan 11, 2017 04:43 AM

    Hello,

     

    I set up a redundant pair of 7030 controllers at a customer. All AP 205 and AP 204 are shown as 802.11n standard in stead of 802.11ac in monitoring-> all access points.

     

    Anyone noticed this before? F/W is 6.5.0.3 but I did a role back to 6.4.3.4 but that didn't change anything. Looks like I'm missing a config setting.

    vap htssid_prof 40Mhz ht and vht enabled.

    RF Management ARM profile 40Mhz (and 80Mhz)

      

    thanks, Erik



  • 2.  RE: Aruba AP 205 802.11n in All Access Points

    EMPLOYEE
    Posted Jan 11, 2017 05:29 AM
    On the command line, type "show audit-trail".

    That will allow you to see what you might have done to make it say 802.11n.

    In the ARM profile, you should make sure that VHT is enabled.


  • 3.  RE: Aruba AP 205 802.11n in All Access Points

    Posted Jan 11, 2017 08:57 AM

    Nothing showing in show audit-trail output. VHT is enabled

     

    Looks like I need to get me an AP 205 in  my lab to figure out what's going on there. 



  • 4.  RE: Aruba AP 205 802.11n in All Access Points

    EMPLOYEE
    Posted Jan 11, 2017 09:13 AM
    Type show "ap bss-table" and see if it says VHT or just HT