Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Aruba IAP305 cannot connect mesh point

This thread has been viewed 3 times

  • 1.  Aruba IAP305 cannot connect mesh point

    Posted Jul 13, 2017 07:09 AM

    I have 2 Aruba IAP305 one connect by cable and one that will not be connected by cable.

     

    In the first setup both IAP are connected by cable.

    Then is disabled extend SSID and set Eth0 Briding enabled on the IAP that will be not connected by cable.

    Rebooted both IAPs and disconnected the cable from the mesh point.

    The IAP will not connected to the mesh portal.

     

    Please could someone advise if I am missing someting.

     

    With kind regards,

    Patrick Hofman