Wireless Access

last person joined: 18 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Aruba RAP in Rc2I mode

This thread has been viewed 2 times

  • 1.  Aruba RAP in Rc2I mode

    Posted Oct 23, 2018 04:57 PM

    I converted IAP 315 to RAP. Now it shows flag as Rc2I. I want this RAP to plug into home network so I can connect back to work network and broadcast work SSIDs. Please help!



  • 2.  RE: Aruba RAP in Rc2I mode

    Posted Oct 24, 2018 02:35 AM

    Which AP-group did you provision this RAP in?

    Does this AP-group have any VAPs active?

    Does the AP stay up permanently with the Rc2I-flags, or does it rebootstrap?



  • 3.  RE: Aruba RAP in Rc2I mode

    MVP EXPERT
    Posted Oct 24, 2018 04:45 AM

    Can you please confirm the last flag you are seeing, is this either "l" or "I".

     

     L = Unlicensed : Check you have enough licenses available for the RAP. (#show license limits)

     

    I = Inactive : As what @dojjan said, check you have the necessary VLAN's in place on the controller which is terminating the RAP. On the controller where the RAP terminates, run the command #show profile-errors to see if there is any errors with your configuration.