Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Aruba Tunelled Node

This thread has been viewed 1 times

  • 1.  Aruba Tunelled Node

    Posted Feb 03, 2013 11:42 PM

    Hi , Has anyone seen any documentation on how tunnelled node works and also how to setup and configure an Aruba Controller and Aruba Switch to utilise tunnelled node. firmware versions required etc.



  • 2.  RE: Aruba Tunelled Node

    Posted Feb 10, 2013 07:25 PM
    It's in the 7.2 user guide - http://support.arubanetworks.com/DesktopModules/Bring2mind/DMX/Download.aspx?TabId=77&DMXModule=512&Command=Core_Download&Method=attachment&EntryId=10228&PortalId=0

    My understanding is the switch forms a gre connection to your controller and creates a "dynamic" vlan for each tunneled port. I had to create and ipsec tunnel, which then tunnels the GRE, as the switch accesses the controller via the Internet (in my case).

    Each tunneled port then uses the 802.1x configuration on the controller



  • 3.  RE: Aruba Tunelled Node

    EMPLOYEE
    Posted Feb 11, 2013 03:15 AM

     

    You can refer to this doc.

    http://www.arubanetworks.com/techdocs/ArubaOS_61/ArubaOS_61_UG/Mux_config.php#XREF_20222_Configuration

     

    There is an example with configuration as well. This was first support on AOS v6.1.x,