Wireless Access

last person joined: 13 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Broadcast filter ARP and all

This thread has been viewed 1 times

  • 1.  Broadcast filter ARP and all

    Posted Dec 20, 2011 03:46 PM

    Has anyone run into issues with broadcast filter ARP and all?  We just upgraded from 3.4.0.4 to 5.0.4.0 and ran into all kinds of issues with WOW connectivity and broadcast.  WOW's would never get an IP address.  We never had broadcast filter ARP or all on before the upgrade but now it's on 3 of 4 SSID's.  The WOW's would not work until broadcast filter ARP was turned on.  I think it was VoIP proxy ARP before version 3.3.  Also, I'm seeing broadcast from some APS and not from others. 

     

    No other changes were made except for the upgrade.  No increase or decrease of clients and the issues were immediately after the upgrade.  Within an hour of turning broadcast filter ARP on, all of issues went away.

     

    We have around 1200 AP,s,8 6000 controllers, and 3000 clients.  APS are a mix of AP 70's and AP 125's.



  • 2.  RE: Broadcast filter ARP and all

    EMPLOYEE
    Posted Dec 20, 2011 06:13 PM

    What is the role that the user gets when the device connects?

     



  • 3.  RE: Broadcast filter ARP and all

    Posted Dec 21, 2011 07:51 AM

    They put into the logon role.



  • 4.  RE: Broadcast filter ARP and all

    Posted Dec 21, 2011 07:56 AM

    They are put into the logon role is what I meant.



  • 5.  RE: Broadcast filter ARP and all

    EMPLOYEE
    Posted Dec 21, 2011 08:30 AM

    I have never seen that.  Maybe someone can comment on that.