Wireless Access

Reply
Occasional Contributor II

CLI Command for Ethernet AP Stats

Hello Everyone 

 

I need to check if some APs are incrementing errors on the ethernet port.

 

Is there any command to verify it ?

 

Regards 

 

Thiago

Re: CLI Command for Ethernet AP Stats

 

Unfortunately no, all you can see is the following :

(MASTER_CONTROLLER) #show ap debug port status ap-name test
AP "test" Port Status
-------------------------------------
Port MAC Type Forward Mode Admin Oper Speed Duplex 802.3az PoE STP TX-Packets TX-Bytes RX-Packets RX-Bytes
---- --- ---- ------------ ----- ---- ----- ------ ------- --- --- ---------- -------- ---------- --------
0 24:de:45:12:ce:2b GE N/A enabled up 1 Gb/s full N/A N/A N/A 968132 326820777 5071733 709857492

 

Thank you

Victor Fabian
Lead Mobility Architect @WEI
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Guru Elite

Re: CLI Command for Ethernet AP Stats

Do you have access to the switch side of the link?






Sent from Windows Mail

| Tim Cappalli | Aruba Security | @timcappalli | timcappalli.me |

NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.
Occasional Contributor II

Re: CLI Command for Ethernet AP Stats

Yes in this case i have access to the switch were the aps are connected, and i´m able to verify it by switch cli, but in some cases i´m unable to access the switch.

 

Anyway, appreciate the help

Guru Elite

Re: CLI Command for Ethernet AP Stats

Try:

show ap debug system-status ap-name <ap-name>

 

ap-if-info.PNG


| Tim Cappalli | Aruba Security | @timcappalli | timcappalli.me |

NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: