I've just installed a new S2500 switch, hooked it up to my core stach (which is Cisco). I did the initial setup config and set up the initial default vlan. Since I only want the one vlan on this particular switch, I stopped there.
If I plug into the switch with my laptop, I pull a DHCP address, I can get out to the internet, I can pull up the aruba controller.
When I plug an access point into the same port on the switch, I get nothing. It powers up, the link shows as up. The DHCP server shows a lease issued in the correct subnet. It just never fully boots because it's not finding the controller. If I plug the AP into a different switch, it boots, loads, and talks just fine.
AP is a 225, switch is brand new. Any suggestions for what to check next?
#AP225