Wireless Access

Reply
Highlighted
Contributor I

Cisco WLC 7.4

Hi,

 

Is it possible to manage/monitor Cisco controllers running 7.4 code ?

 

 

Thanks


Accepted Solutions
Highlighted
Moderator

Re: Cisco WLC 7.4

No specific support has been added for Cisco controllers on firmware 7.4.x.x.  The last tested version was 7.3.101.0 in AMP 7.6.

 

If you're running AMP 7.6 and are seeing anything not working properly, it's worth it to open a support case.

 

If you're asking as a prior measure before upgrading your controller firmware, typically monitoring will be available.  Management of new features may not be included (these would be worth filing as feature requests in the Ideas Portal on the support site for future improvement).


Rob Gin
Senior QA Engineer - Network Services
Aruba Networks, a Hewlett Packard Enterprise Company

View solution in original post


All Replies
Highlighted
Moderator

Re: Cisco WLC 7.4

No specific support has been added for Cisco controllers on firmware 7.4.x.x.  The last tested version was 7.3.101.0 in AMP 7.6.

 

If you're running AMP 7.6 and are seeing anything not working properly, it's worth it to open a support case.

 

If you're asking as a prior measure before upgrading your controller firmware, typically monitoring will be available.  Management of new features may not be included (these would be worth filing as feature requests in the Ideas Portal on the support site for future improvement).


Rob Gin
Senior QA Engineer - Network Services
Aruba Networks, a Hewlett Packard Enterprise Company

View solution in original post

Highlighted
Contributor I

Re: Cisco WLC 7.4

Ok, thanks Rob

Highlighted
MVP Expert

Re: Cisco WLC 7.4


@rgin wrote:

No specific support has been added for Cisco controllers on firmware 7.4.x.x.  The last tested version was 7.3.101.0 in AMP 7.6.

 

If you're running AMP 7.6 and are seeing anything not working properly, it's worth it to open a support case.

 

If you're asking as a prior measure before upgrading your controller firmware, typically monitoring will be available.  Management of new features may not be included (these would be worth filing as feature requests in the Ideas Portal on the support site for future improvement).


Can documentation get updated because as of 7.7.8 it says the following:

Capture.PNG