Wireless Access

Reply

ClientMatch Issue

Hi folks,

i have the Sticky client issue in a WLAN , and i'm using 6.4 firmware, so my question si :

 do client match works with all AP or with new Generation AP2XX only.

Regards.


Raouf CHAHBOUNE
ICT Network & Security Engineer
CCNP R/S | CCNA Security | ACMP|ACCP|ACDX



[If my post is helpful please give kudos, or mark as solved if it answers your post.]
Guru Elite

Re: Client Much

ClientMatch works with 11n and 11ac access points.

| Tim Cappalli | Aruba Security | @timcappalli | timcappalli.me |

NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.

Re: Client Much

and in the two band (2.4 and 5 Ghz)


Raouf CHAHBOUNE
ICT Network & Security Engineer
CCNP R/S | CCNA Security | ACMP|ACCP|ACDX



[If my post is helpful please give kudos, or mark as solved if it answers your post.]
Guru Elite

Re: Client Much

Yes

| Tim Cappalli | Aruba Security | @timcappalli | timcappalli.me |

NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.
Guru Elite

Re: Client Much


rchahboune wrote:

and in the two band (2.4 and 5 Ghz)


If your AP power is too high, (more than 18dbm), Clientmatch will probably not help, because your clients will continue to hang onto the same AP.  If you have not done so, please try to constrain your MIN TX to 12 and your max tx to 18 in your ARM profile.


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: