Hi Guys,Im in need of your help! We currently have a 3200 controller in a data centre which our servers site behind. All of our branches have RAP5s or RAP155s that connect to the 3200 to provide access to the servers from the computers behind the RAPS.
At our HQ we have some AP93s that were working untill we did the latest upgrade to the firmware on the 3200, we have since found out that AP93s are not supported behind a RAP so decided to replace the RAP5 at the HQ with a 650 controller.
We had an aruba specialist in to do the work for us but basically they are saying that the solution they have provided wont do what we are currently doing....
I have attached 2 simple diagrams of current setup and what we want the 650 to do in the new setup. In my head what im asking for is completely logical and seems to be quite a normal setup from what I have read and been told by others..
All we want is for local computers to be able to work as before and for us to be able to use the AP93s that we have... Is that to much to ask??
They are saying that we need to have something else infront of the 650 performing the VPN to the 3200 to enable local clients to connect to the servers at the data centre, is this correct?
My understanding is that we can connect a modem to the adsl line and give the 650 a static external IP and connect directly to the 3200 to setup as local to the master as well as performing the VPN tunnel?
Any clarification here would be greatly appriciated!
Thanks in advance
Anthony
#3200