Wireless Access

New Contributor

Copies config to new controller

I copied the Config from an existing 650 controller and pasted it to an new controller.  Everything is working however  the enable  password is not the same as the config donor controller..  In the notepad  It is listed as    enable secret "******"   Should have cleared this line before pasting but did not.    is there a way from the GUI to change the CLI enable password?  Is there a console port  password recovery?  Hope to do this remotely thru GUI as this controller is 200 hundred miles away




Guru Elite

Re: Copies config to new controller

The controller wizard will allow you to change it.


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Search Airheads
Showing results for 
Search instead for 
Did you mean: