Wireless Access

last person joined: 15 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Deleted

This thread has been viewed 5 times

  • 1.  Deleted

    Posted May 29, 2018 03:31 AM


  • 2.  RE: Deleted

    EMPLOYEE
    Posted May 29, 2018 07:43 AM

    Check this post on how to load the AP firmware from the controller again.



  • 3.  RE: Deleted

    Posted May 30, 2018 02:37 AM

    Thank you for your help, Herman Robers!

     

    I've tried several times but no luck :(

     

    P.s I running a VC on IAP-205, firmware 6.5.4.7, IP 10.10.10.14.

     

    eth0 up: 1 Gb/s full duplexri
DHCP broadcast 1
DHCP IP address: 10.10.10.16
DHCP subnet mask: 255.255.255.0
DHCP def gateway: 10.10.10.1
DHCP DNS server: 8.8.8.8
DHCP DNS domain: XXXXXXXXXX
Using eth0 device
TFTP from server 10.10.10.14; our IP address is 10.10.10.16
Filename 'armv7ns/ari'.
Load address: 0x4100000
Loading: T T T T T T T T T T
Retry count exceeded; starting again

     



  • 4.  RE: Deleted

    Posted Nov 16, 2019 02:15 PM

    Have you deleted the firmware atleast one time?



  • 5.  RE: Deleted

    EMPLOYEE
    Posted Nov 18, 2019 03:12 AM

    Only Instant APs (type number IAP-207-xx) can join an Instant cluster. If you have an AP-207 (Campus AP), you will need a controller for it to operate.