I am working on linking two buildings with a pair of IAP-277s.
I followed the instructions here: http://community.arubanetworks.com/t5/Controllerless-Networks/IAP-277-point-to-point-bridge-configuration/td-p/250094
But it's still not working.
I see the one connected to the primary building along with the rest of the APs and if I remove the one from the remote building and bring it online in the primary building it shows up fine.
Any thoughts? Doing all this in the GUI. It's probably heresy but I'm not a CLI person.
It ended up being incorrect PoE injectors supplied by our vendor. One hurdle down, one left.
The bridges now see each other but the point AP does not pass DHCP and therefore traffic. Any thoughts there?
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.