Wireless Access

AP105 , 125 & 135 arfe high density APs ... while AP90 is not

what  deos high density means ?  can have more users associated ?  how much ?

Hi,

Good evening,:smileyhappy:

High Density = Large number of users / Large number of AP'S -usually overlapping each other / Large number of client demands for different QOS over the air  and more...

The AP-9X isn't for high density mainly because the reason at cannot give access in both spectrums simultaneously (2.4+5) no band sterring | no 2.4GHZ=20mhz+5GHZ=40mhz. = 600Mbps

Here is an example for High Density environment:

This is the full article:

http://www.arubanetworks.com/wp-content/uploads/dg_highdensity_vrd.pdf

More good info:

http://www.arubanetworks.com/pdf/technology/TR_HiDensityWiFiBenchmark.pdf

http://networktest.com/arubaarm/arubaarm1.pdf

have a lovely night. :smileywink:

me

AP-105 is suitable for ceil mounting because it is downtilt antenna . i caanot understand that ?

it is omni directional @ the end ?  

Here is AP-105 in ACTION :)

AP-105 antenna pattern plots

Thx , u got the point ... i know the pattern plot but cannot differentiate/ understand it  ... i know one is vertical & other if horizontal ... what what is difference comparing to AP-93 pattern plots ?

AP-93 AND AP-105

BOTH GOT 2X2 Antennas - both of the units using Omni built in antennas.

The pattern plot of Omni antenna of all unit will look almost the same... Because it's Omni :)

Hi

I did some small compare using the datasheets of both products for u. (its not that accurate)

It will give to the ideas that it's only a small different between two pattern plots.