Wireless Access

In the CLI on a ArubaOS (MODEL: Aruba7220-US), Version 6.5.3.3 controller and I use the command: #show ap association. In the bottom of the output I notice that it shows me:

Total num of single-band only clients:8

How do I find out which 8 clients those are?

Also, are there any tools that help with this in Airwave?

Thanks!!

Rob

show ap association | exclude B

This gets me close but l'm not sure how to interpret the result. For example I receive:

Num Clients:913
Total num of dual-band capable clients:846
Total num of dual-band capable clients in 2.4G band:62
Total num of dual-band capable clients in 5G band:784
Total num of single-band only clients:6

#show ap association | exclude B gives me the following output:

23 clients are listed that are authenticated (auth: y) but not associated (assoc: n). Then there is a single client that is authenticated and associated and shows all the SSID information, phy, assoc. time, etc.

The "Num Clients" = 913. But then I do "total of dual-band capable" + "single band only" = 852.

A few questions about this:

-Why the discrepancy in the amount of clients compared to dualband/singleband?

-Why does it mean that I have 23 clients that are authenticated but not associated?

-Also, the command you provided shows one client that is not capable of Band Steering, but the summary says there should be 6 single band only clients.

You should go to Dashboard> Clients to see the total and the breakdown.

---

@peebles413 wrote:

This gets me close but l'm not sure how to interpret the result. For example I receive:

 

Num Clients:913
Total num of dual-band capable clients:846
Total num of dual-band capable clients in 2.4G band:62
Total num of dual-band capable clients in 5G band:784
Total num of single-band only clients:6

 

#

 

---

it's meant to match up, here is an example

Num Clients:127
Total num of 5G capable clients:126
Total num of 5G capable clients in 2.4G band:22
Total num of 5G capable clients in 5G band:104
Total num of 2.4G only clients:1

a clue should be able to be found in the combined output of these:

no paging
show ap association
show user-table
show ap ess
show ap arm client-match summary

if you DM it to me I can have a look, else, raise a tac case if you're on a recent software version