I'm going to be deploying RAPS at remote sites using shared private network only has 45 meg tottal to the site. I would like to limit all wireless traffic per access point to 10 Meg by AP-group. That way I can have my techs put the new AP in that AP group. I see a few places I can do it one is I can setup a user roll with bandwidth statement of 10 meg then set it on the AP system session ACL. I also see down below on the ap system profile remote AP Remote-AP uplink total bandwidth can I use that? I'm not sure exactly where. I know that session BW limits are set per user but if enough users were at the site still could over load the 45 meg limit of the microwave system there.