Wireless Access

last person joined: 22 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

I am unable to create a vlan pool by either cli or gui. What should I do?

This thread has been viewed 0 times

  • 1.  I am unable to create a vlan pool by either cli or gui. What should I do?

    Posted Dec 24, 2014 11:49 AM

    I have 4 3400 controllers running 6.3 and I am unable to create a vlan pool on my slave controllers.  My Master works fine but it will not allow creation on the slaves.  Any ideas?

     

    Thanks,



  • 2.  RE: I am unable to create a vlan pool by either cli or gui. What should I do?
    Best Answer

    EMPLOYEE
    Posted Dec 24, 2014 12:02 PM
    The vlan pools are created on the master and get pushed down to the locals when you save config. The only piece you would do on the local is map VLAN IDs to the the pool.


  • 3.  RE: I am unable to create a vlan pool by either cli or gui. What should I do?

    Posted Jan 03, 2015 05:15 AM

    the vlan pools can be created in the master  controller only , but you should map vlans ID to those vlan pools from local controllers