Wireless Access

Reply
Highlighted
New Contributor

IAP-314 Antenna Cable Connection to D100 4X4 OUTDOOR MIMO ANTENNA Q8N50A

We are going to install IAP-314 which has Four Antenna (ANT0,1,2 & 3), which will be connected to D100 4X4 OUTDOOR MIMO ANTENNA Part#Q8N50A.

This Antena has four ports (-45 ,  +45 , V & H).

I would like to know is there a specific way that these Antenna ports from IAP 314 (ANT0,1,2 & 3) connect to particular ports on Outdoor Antenna box ports (-45 ,  +45 , V & H)?


Accepted Solutions
Highlighted
All-Decade MVP 2020

Re: IAP-314 Antenna Cable Connection to D100 4X4 OUTDOOR MIMO ANTENNA Q8N50A

Should not matter. For Beam forming or anything else the AP will measure the signal it sees on each connection, it does not matter which order they are plugged in. 

-------------------
ACDX, ACCP, CISSP, CWNA

View solution in original post


All Replies
Highlighted
All-Decade MVP 2020

Re: IAP-314 Antenna Cable Connection to D100 4X4 OUTDOOR MIMO ANTENNA Q8N50A

Should not matter. For Beam forming or anything else the AP will measure the signal it sees on each connection, it does not matter which order they are plugged in. 

-------------------
ACDX, ACCP, CISSP, CWNA

View solution in original post

Highlighted
MVP Expert

Re: IAP-314 Antenna Cable Connection to D100 4X4 OUTDOOR MIMO ANTENNA Q8N50A

Note, beamforming is not very effective when using directional antennas, just an FYI. 

 


Jerrod Howard
Distinguished Technologist, TME
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: