Wireless Access

last person joined: 22 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

IAP-314 Antenna Cable Connection to D100 4X4 OUTDOOR MIMO ANTENNA Q8N50A

This thread has been viewed 4 times

  • 1.  IAP-314 Antenna Cable Connection to D100 4X4 OUTDOOR MIMO ANTENNA Q8N50A

    Posted May 29, 2018 12:45 PM
      |   view attached

    We are going to install IAP-314 which has Four Antenna (ANT0,1,2 & 3), which will be connected to D100 4X4 OUTDOOR MIMO ANTENNA Part#Q8N50A.

    This Antena has four ports (-45 ,  +45 , V & H).

    I would like to know is there a specific way that these Antenna ports from IAP 314 (ANT0,1,2 & 3) connect to particular ports on Outdoor Antenna box ports (-45 ,  +45 , V & H)?



  • 2.  RE: IAP-314 Antenna Cable Connection to D100 4X4 OUTDOOR MIMO ANTENNA Q8N50A
    Best Answer

    Posted May 29, 2018 01:54 PM

    Should not matter. For Beam forming or anything else the AP will measure the signal it sees on each connection, it does not matter which order they are plugged in. 



  • 3.  RE: IAP-314 Antenna Cable Connection to D100 4X4 OUTDOOR MIMO ANTENNA Q8N50A

    EMPLOYEE
    Posted Jun 07, 2018 03:44 AM

    Note, beamforming is not very effective when using directional antennas, just an FYI.