Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Issues to save Firewall AMSDU configuration on Aruba OS 5.0.3.0

This thread has been viewed 1 times

  • 1.  Issues to save Firewall AMSDU configuration on Aruba OS 5.0.3.0

    Posted Aug 08, 2013 12:04 PM

    Hi,

     

    In order to solve the new iMac connection issues, I enabled A-MSDU aggragation mode on controllers by using the following commands:

    # firewall amsdu

    show firewall and amsdu is enabled

    # write mem

    # reload

    But AMSDU mode is still disabled after rebooting. seems AMSDU configuration can not be saved. I tried this on Aruab6000, Aruba3600 and Aruba3200 but no luck. After rebooting, "AMSDU enable" is gone. All my controllers are using Aruba OS 5.0.3.0.

    Any advices will be really appreciated.

    thanks,

     



  • 2.  RE: Issues to save Firewall AMSDU configuration on Aruba OS 5.0.3.0

    Posted Aug 08, 2013 02:44 PM

     

     

    You should just probably open a TAC case or consider upgrading to a more recent AOS code

     

    Have you tried doing this through the GUI instead ?



  • 3.  RE: Issues to save Firewall AMSDU configuration on Aruba OS 5.0.3.0

    Posted Aug 09, 2013 10:49 AM

    THanks, I tried to find the settings for AMSDU aggregation mode through Web interface but I was not able to find it.



  • 4.  RE: Issues to save Firewall AMSDU configuration on Aruba OS 5.0.3.0

    Posted Aug 09, 2013 12:01 PM

     

    Try in the Configuration>Statefull Firewall

     

     



  • 5.  RE: Issues to save Firewall AMSDU configuration on Aruba OS 5.0.3.0

    Posted Aug 09, 2013 12:26 PM

    I could not find the "AMSDU" settings under "Configuration/Stateful Firewall" on GUI.

     

    thanks,