Hello,
Although I've been an "Airheads" for well over an year, this is my first topic.
Until today, I used a Meraki access point on my home network. I have just installed the Aruba access point which I purchased a while ago.
I am using Arch Linux with KDE Plasma on my personal laptop and my phone is an Android device.
KDE connect whoch allows me, amongst other features, to wirelessly transfer files between my laptop and my phone, was warking fine until the access point swap.
According to KDE community:
"KDE Connect uses dynamic ports in the range 1714-1764 for UDP and TCP. So if you are behind a firewall, make sure to open this port range for both TCP and UDP. Otherwise, make sure your network is not blocking UDP broadcast packets.".
I am using Aruba Central to manage the access point and my setup is as below:
Aruba Instant Access Point: IAP-324-WR (6.4.4.4-4.2.3.0_54225)
Laptop with Arch Linux and KDE Plasma (Kernel: Linux 5.0.0-arch1-1-ARCH)
Could anyone point me into how to check / adjust the settings for KDE Connect? Again, the laptop - phone pair was working fine before changing the AP.
Thank you for any feedback you may have.