Wireless Access

Reply

Re: Max EIRP by Country Code

AOS 6.5 on a US controller - 

(Aruba7005) #show ap allowed-max-EIRP ?

ap-name                 Name of Access Point

ip-addr                 Filter on IP Address

 

(Aruba7005) #show ap allowed-max-EIRP ap-name 325 ?

|                       Output Modifiers

<cr>

 

(Aruba7005) #show ap allowed-max-EIRP ap-name 325

 

I will check with engineering.

 


Jerrod Howard
Distinguished Technologist, TME

Re: Max EIRP by Country Code

The power and channel limits are based on regulatory domain. Consider this Ap is provisioned in US regulatory domain profile and below command output will show the max allowed EIRP.

#show ap allowed-max-EIRP ap-name <Ap-name> country-code US

(Aruba) #show ap allowed-max-EIRP ap-name 6c:f3:7f:c7:41:bc country-code us
*****************2Plus Wireless Solutions****************************
Aruba Airheads - Powered By community for empower the community
************ Don't Forget to Kudos + me,If i helped you******************

Re: Max EIRP by Country Code

try: (in 6.5)
to view the current Regulatory-Cert, use the show ap regulatory command.
*****************2Plus Wireless Solutions****************************
Aruba Airheads - Powered By community for empower the community
************ Don't Forget to Kudos + me,If i helped you******************

Re: Max EIRP by Country Code

seems that in 6.5 cli guide..the command isnt there :(
*****************2Plus Wireless Solutions****************************
Aruba Airheads - Powered By community for empower the community
************ Don't Forget to Kudos + me,If i helped you******************

Re: Max EIRP by Country Code

I will find out if the removal of said command was intentional in 6.5+ or a bug :) Thanks Kdisc!


Jerrod Howard
Distinguished Technologist, TME
Frequent Contributor II

Re: Max EIRP by Country Code

any follow up? I need the Max EIRP for the USA for AP 315 

Guru Elite

Re: Max EIRP by Country Code

Moderator

Re: Max EIRP by Country Code

actually.... and at the risk of this snowballing the discussion:

 

show ap allowed-max-EIRP is deprecated (quite a while ago)

 

the new command is

show ap debug power-table ap-name <ap> radio [0|1]

 

this came about because of changes to the way we have to sum up power for multi chain APs together with beam forming etc etc.

 

The CLI output is lengthy, but it's somewhat self explanatory (read the info at the bottom of the output). As with the previous show ap allowed-max-EIRP it only works for an AP on the controller itself.

 

tl;dr; there is a new cli command which shows tx powers per rate per bandwidth per modulation per # chains etc.

 

 

 

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: