Wireless Access

Reply
Highlighted

Mounting options for AP 225

Good Afternoon Airheads,

     I'm looking for some advice regarding mounting an AP 225.  I'm replacing an existing Cisco AP and the the mounting location is on the underside of a steel I-beam/girder in a warehouse environment about 30 ft in the air.  All I have been able to find officially is the wall mounting kit when what I believe I need is more of a mounting plate and clamps of some sort.  Just looking for some direction from folks who may have dones something like this before to see what they used.

 

Regards,

 

Bill Fischer

Versatile Inc.


Accepted Solutions
Highlighted
Aruba

Re: Mounting options for AP 225

You can consider using a standard Aruba mount kit with standard "C"/Beam clamps.   Such as Granger 3KF30 to mount it to the I-Beam.

 

800px-I-Beam_Clamp_AP135.jpg

------------------------------------------------
Systems Engineer, Northeast USA
AMFX | ACCX | ACDX | ACMX

View solution in original post


All Replies
Highlighted
Occasional Contributor I

Re: Mounting options for AP 225

I have used the wall mount bracket (AP-220-MNT-W1) in a steel beam using self tapper screws. Mounted to both wall and ceiling.

Highlighted
Aruba

Re: Mounting options for AP 225

You can consider using a standard Aruba mount kit with standard "C"/Beam clamps.   Such as Granger 3KF30 to mount it to the I-Beam.

 

800px-I-Beam_Clamp_AP135.jpg

------------------------------------------------
Systems Engineer, Northeast USA
AMFX | ACCX | ACDX | ACMX

View solution in original post

Highlighted
Occasional Contributor I

Re: Mounting options for AP 225

 
Highlighted

Re: Mounting options for AP 225

Thanks very much.  This is going to work perfectly.

Highlighted
New Contributor

Re: Mounting options for AP 225

Is that an AP enclosure?  If so, what is the model/part number?

Highlighted
New Contributor

Re: Mounting options for AP 225

What type of screws did you use with the C beam clamps on the plastic mount kit?